Drive mounted with sshfs has non-descriptive name [CLOSED]
Posted: Thu May 02, 2019 4:59 pm
I mount network locations using `sshfs network_folder existing_local_folder`. In terminal, localfolder looks like a regular folder, but contains the contents of network_folder. However, in NC, both network locations are called "OSXFUSE Volume #", without anything to indicate the name of existing_local_folder.
When I have mounted a few locations in this way, it gets confusing. For example, in the following screenshot, the folders "odin" and "herm" each correspond to a sshfs network drive. But in NC, there is no way to tell which OSXFUSE Volume corresponds to which folder, except to open the folder and look at its contents. With more than two mounts, this gets very confusing.
Is it possible to get the folder names to show up in NC?
In the screenshot, you see my terminal `ls` on the left, and NC is on the right.
Thanks
When I have mounted a few locations in this way, it gets confusing. For example, in the following screenshot, the folders "odin" and "herm" each correspond to a sshfs network drive. But in NC, there is no way to tell which OSXFUSE Volume corresponds to which folder, except to open the folder and look at its contents. With more than two mounts, this gets very confusing.
Is it possible to get the folder names to show up in NC?
In the screenshot, you see my terminal `ls` on the left, and NC is on the right.
Thanks